ShiftFX Support

Quickshifter FAQ

How do I tell if my a quickshifter is push or pull type?

The Nextup quickshifter is setup to work in push or pull directions. A "pull" type quickshifter has a machined groove, or mark, just after the threaded rod. Push–pull conversions kits are available which include a replacement part and special tool for taking the quickshifter apart.

quickshifter identification

How should I install my quickshifter?

The rod kit included with your quickshifter can be setup in 6 different ways to best suite your gear shifter arrangement. The quickshifter should be installed so that it does not interfere with the shift lever or the riders boot. Several threads should be engaged at all ends to prevent accidental pull-out. Jam nuts should be used at all ends to prevent accidental pull-out. The setup should create square, 90° angles, at both ends. The cable should be tied down away of moving parts, with enough slack to permit shifting in both directions.

quickshifter installation

How do I setup Engine Kill and Delay times?

A properly setup quickshifter will:

  • Only work during upshifts
  • Quickly and smoothly change gears without upsetting the chassis
  • Work without use of the clutch
  • Work without the need to back off the throttle

Achieving good results requires smooth but firm foot action and some software tuning. If your setup includes the Nextup Contoller then tuning can be done right on the box without the need for a laptop. Use this guide or watch this video to tune your Nextup Controller. If your setup includes a 3rd party controller then follow their software instructions to tune the quickshifter.

 

Drag FAQ

How should I setup my Air Shifter?

The key to a good air shifter setup is a proper connection between the air cylinder and the gear shifter. A solid mount that stands off the frame is the starting point for this connection. The mount should stand off of the frame far enough so that the rod clevis easily slots over the shift lever. Locating the mount to create a square, 90° angle, connection to the shift lever ensures good action. A properly mounted cylinder will stroke freely in both directions and not cause the gear lever to drag or bind.
air cylinder support exploded view air cylinder support assembled view

How do I setup Engine Kill and Delay times?

A properly setup air shifter will:
  • Upshift at the press of a button
  • Quickly and smoothly change gears without upsetting the chassis
  • Work without use of the clutch
  • Work without the need to back off the throttle

Achieving good results requires some software tuning. If your setup includes the Nextup Contoller then tuning can be done right on the box without the need for a laptop. Use this guide or watch this video to tune your Nextup Controller.

Contact us if you have other questions.